Hydraulic Motor

Hydraulic motors - how dry starts damage them

I was asked recently to conduct failure analysis on a hydraulic motor that was the subject of a warranty claim. The motor had failed after only 500 hours in service, some 7,000 hours short of its expected service life.

Inspection revealed that the motor's bearings had failed through inadequate lubrication, as a result of the hydraulic motor being started with insufficient fluid in its case (housing).

A common misconception among maintenance personnel with limited training in hydraulics, is that because oil circulates through hydraulic components in operation, no special attention is required during installation, beyond fitting the component and connecting its hoses. Nothing could be further from the truth.

After this hydraulic motor was installed, its case should have been filled with clean hydraulic oil prior to start-up. Starting a piston-type motor or pump without doing so, is similar to starting an internal combustion engine with no oil in the crankcase - premature failure is pretty much guaranteed.

Some of you may be thinking that the case should fill with hydraulic fluid through internal leakage. In most cases it will, but not before the motor or pump has been damaged. In many cases, this damage may not show itself until the component fails prematurely, hundreds or even thousands of service hours after the event.

In this particular example the warranty claim was rejected on the basis of improper commissioning and the customer was lumbered with an expensive repair bill.

How can this type of failure be prevented?

This example highlights the importance of following proper commissioning procedures when installing hydraulic components. As in this example, if the case of the hydraulic motor had been filled with fluid prior to start-up, the failure of this motor and the significant expense of its repair could have been prevented.

Editor's note: for more information on hydraulic failures and how to prevent them, read Preventing Hydraulic Failures.

If you enjoyed this article, you'll love Brendan Casey's Inside Hydraulics newsletter. It gives you real-life, how-to-do-it, nuts-and-bolts, hydraulics know-how – information you can use today. Listen to what a few of his subscribers have to say:

Can't Put It Down
“I get magazines and e-mails like this all the time. I never find time to read them. I decided to read Issue #30 and I couldn't put it down. I'll make time from now on.”

Richard A. Shade, CFPS
Project Engineer (Hydraulic Design)
JLG Industries Inc.

So Valuable It Earned Me A Raise
“The knowledge I've gained from this newsletter has been so valuable it has earned me a raise!”

Jack Bergstrom
Heavy Equipment Mechanic
Sharpe Equipment Inc.

Love It - Keep Them Coming
“I just love this newsletter. As a Hydraulics Instructor for Eaton, I make copies and distribute them to my students as I address various topics... Keep 'em coming.”

Michael S Lawrence
Hydraulics Instructor
Eaton Hydraulics Inc.

Here's a sample of what's covered in this powerful newsletter: troubleshooting, contamination control, component repair and testing, preventative maintenance, failure analysis, and much, much more!

To get a FREE subscription to the Inside Hydraulics newsletter, fill out this form - don't forget to capitalize the first letter of your name - and hit 'SUBSCRIBE NOW!'

First Name *
Email *

This is a private mailing list that will never be sold or given away for any reason.
You can also unsubscribe at anytime.



[Home]


Copyright © 2002 - 2013 Brendan Casey; Insider Secrets to Hydraulics